Try adding "ForceGpuPhysics=1" ?
Or I could rely on FIRST HAND experience with 2 7950s where if I disable CF I get HALF the frames that I get with CF enabled. Windowed mode...
Yes, EVGA has also a good track record at supporting (unusally) high resolutions.
I'll drop this here: http://bitsum.com/pl_when_hyperthreading_hurts.php For just gaming, you don't really need anything more than a i5 at the moment...
Are you sure you have the ports PS2 needs open/forwarded in your router?
https://docs.google.com/spreadsheet/ccc?key=0AhEqOKDInCUEdE5aNDMzWm5UdTBZaFlSalJTeXNmMkE#gid=0 See "Ultra Testing" tab for which settings have been...
I have some bad experiences with ASUS, their RMA is pretty bad. So I would get the Gigabyte version.
Well to be fair, I went from 30-40fps at "Ultimate" to 60-70 at "Ultimate" with 7950 CF after a few patches. And I haven't really had any...
My bad, misread your post. Have you tried deleting useroptions.ini, since you shouldn't be getting 5fps at lowest settings.
Official word: "FurMark is a very intensive OpenGL benchmark that uses fur rendering algorithms to measure the performance of the graphics card. Fur...
https://twitter.com/j_smedley/status/327485923044507648 Hopefully it means it's going to be finally worked on. Need higher vehicle FOV so bad after...
Crossfire works just fine for me, with two 7950's. @ OP, try RadeonPRO and set the Crossfire mode to AFR or Supertile. I prefer Supertile, as it...
Can you check if you have both GPUs active? Either in Afterburner: click settings, under general you should have a drop-down menu under Master...
I meant that the CF Supertile mode itself isn't getting any publicity on tech sites like tpu or toms or guru3d etc. Or why it's not a option in...
No, Furmark uses various methods to maximize power draw and heat generation. With Furmark, I can hit ~80-85C, depending on how much voltage I push....
If you can't upgrade your CPU at the moment, consider overclocking it. But really, it's three generations old, time to send it up-state to a farm...
I have a 7950 CF setup and I do notice micro-stutter (most noticeable if FPS drops below 60) if I use AFR or Driver Default settings. However, if I...
Turning Shadows off would also give you some extra FPS, if you haven't done so already. (Open UserOptions.ini, find ShadowQuality=X, and change the X...
I got 60fps+ in heavy fighting pre-GU4 Betaplayer. They've also said that they are aware of the issue and trying to fix it. And current GPUs almost...
Can't you set the extra buttons to work as keyboard buttons. For example I've got two buttons on my Lachesis set up to act as "U" and "J" buttons on...
Separate names with a comma.
