Try adding "ForceGpuPhysics=1" ?
Or I could rely on FIRST HAND experience with 2 7950s where if I disable CF I get HALF the frames that I get with CF enabled. Windowed mode...
Yes, EVGA has also a good track record at supporting (unusally) high resolutions.
I'll drop this here: http://bitsum.com/pl_when_hyperthreading_hurts.php For just gaming, you don't really need anything more than a i5 at the moment...
Are you sure you have the ports PS2 needs open/forwarded in your router?
https://docs.google.com/spreadsheet/ccc?key=0AhEqOKDInCUEdE5aNDMzWm5UdTBZaFlSalJTeXNmMkE#gid=0 See "Ultra Testing" tab for which settings have been...
I have some bad experiences with ASUS, their RMA is pretty bad. So I would get the Gigabyte version.
Well to be fair, I went from 30-40fps at "Ultimate" to 60-70 at "Ultimate" with 7950 CF after a few patches. And I haven't really had any...
My bad, misread your post. Have you tried deleting useroptions.ini, since you shouldn't be getting 5fps at lowest settings.
Official word: "FurMark is a very intensive OpenGL benchmark that uses fur rendering algorithms to measure the performance of the graphics card. Fur...
https://twitter.com/j_smedley/status/327485923044507648 Hopefully it means it's going to be finally worked on. Need higher vehicle FOV so bad after...
Crossfire works just fine for me, with two 7950's. @ OP, try RadeonPRO and set the Crossfire mode to AFR or Supertile. I prefer Supertile, as it...
Can you check if you have both GPUs active? Either in Afterburner: click settings, under general you should have a drop-down menu under Master...
Separate names with a comma.